Bag Anchor Clip Attaches to the inside of: Ktek Stingray bags Orca bags Schatler/Petrol Bags Protogear Bags Any Receiver Sleeve The Bag Anchor is designed to hold BPS units in a receiver strap or other loops. To use this clip pull all of the cables up though the strap and plug them into the BPS. Push the BPS down through the strap and then stretch the strap between the points of the anchor. This will prevent the BPS unit from pulling out of the strap. Molle Clip Attaches to the outside of: Ktek Sting Bags Any MOLLE ba 1 or 2 loops The MOLLE Clip is designed to work with both one and two rows of MOLLE straps. For use on one row orient the clip like the image on the left, for two rows orient it like the image on the right. One Strap Push the long arms down into the MOLLE strap until the tabs are through the bottom. Push inwards on the tabs and pull down until the crossbar rests on the strap Two Strap Push the long arms up into the top MOLLE strap until the tabs clear. Push inwards on the tabs until the long arms are all the way through the strap. Insert the short arms into the bottom row and push the clip down until it is firmly seated. Buddy Lok Style Clip Attaches to the outside of: Orca Bags The Buddy Lok Style clip attaches to the mating surface found on Orca Bags. Turn the clip 90 degrees and slid it into the mating surface. Rotate it back vertically and it will lock in place. Mod-U-Lox Style Clip Attaches to the outside of: Schatler/Petrol Bag Protogear Bags The MOD-U-LOX Style clip attaches to the mating surface on Petrol, Schatler and Protogear bags. Simply slide it in and it will lock in place. To release it push in on the tab on the top of the mating surface.
